Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Austin 16 King pin removal #7883
    Kenhenryboy
    Participant

    Hello all, Unable to locate a puller, I was forced to knock the pin downwards and out.

    It was a slow process but went quite well.  Studying the bushes, I could see they were quite worn and had in fact been put in wrong, as the grease hole in the bushes didn’t align with the grease nipples. Being unable to get lube in the correct place was the cause of that swivel pin being worn out. Leaving the bushes in was no longer an option and it wasn’t too difficult to get them out with the correct drifts.

    Getting the new bushes in was straightforward enough, but I had to drill holes to align with the ho;e on the axle. It is important that if anyone has to do that, the holes must dissect the small spiral grease channel that is on the inside of the bush cylinder.

    No garage or workshop near me has a reamer so I bought an adjustable one that was the size range I needed. Time-consuming job but when the pins slide in, very rewarding.

    So I am now at the rebuild stage and am putting my brake shoes back on. When I dismantled them at the start, a small keyway-type piece fell to the floor and I just can’t work out where it should go. It is a small trapezium-shaped piece of metal, about the thickness of the brake shoe web, It is about 22mm long and 10mm deep. there are two cut-out corners on one long side and it is not shown on my exploded drawing of a front wheel brake,

    Can anyone help me with identifying this piece and where it should be fitted?

    Thank you

     

    in reply to: Austin 16 King pin removal #7835
    Kenhenryboy
    Participant

    Hello Merlin,

    Thank you for your comments.

    I have removed the welch plug as you suggested, before I go any further, are you saying that the swivel pin must be pulled, or pushed up only?

    I was intending to knock it downwards and out. What do you think?

    Thanks again, Ken

     

    in reply to: Austin 16 King pin removal #7829
    Kenhenryboy
    Participant

    Thank you for the copy of the relevant pages of the front hub. I can see that the cotter in the picture is the same as the new ones I have. i.e. with a part circle removed to allow for the swivel pin to pass by. That means no need to remove the cotter pin, just loosen the nut and a gentle tap on both sides will do, I hope.

    in reply to: Austin 16 BS1 front grille removal. #5635
    Kenhenryboy
    Participant

    Thank you for your reply, and the very useful tip.

    I will make a start this week end.

    I will check out the latest mag, I presume I am looking for an advert?

    Thanks again,

    Ken

    in reply to: AUSTIN 16 BS1 just lost all electrical power? #5615
    Kenhenryboy
    Participant

    Hi Peter,

    The whole car was completely dead, electrically.

    I had 13V at the battery and solenoid but while I was checking those I found another supplementary fuse box had been fitted, a bit tucked away, and sure enough there was a blown fuse. It was a 15A. The cable in and out are at least 2.5mm2, so I will be up rating the fuse to 20A.

    Looking back on it, I had all the electrical components ‘on’ indicators, semaphore trafficators, fan and when I braked, the  brake lights proved to be  the last straw, and that blew the fuse.

    I have learned more about my old car, obviously the supp. fuse box is not original.

    Thank you for your interest, and for your help.

    Kind regards, Ken

Viewing 5 posts - 1 through 5 (of 5 total)